Rugged-ridge Tail Light Euro Guards, 07-14 Jeep Wrangler (JK) Bedienungsanleitung PDF herunterladen

2007 Jeep® JK Wrangler H/D Taillight Guards Kit

11226.02 (Black)

11103.03 (Stainless Steal)

Components:

(1) Driver’s side rear guard (1) Passenger’s side rear guard

(8) Black plastic taillight lens spacer (4) Small 2” Philips head screw

(4) Large 2” Philips head screw

Installation Instructions:

Note: Early 2007 JK’s were supplied with torx head screws to retain the rear lens. If

your JK Wrangler has these torx head screws you will need a T20 screw driver for

removal. This kit replaces these screws with a standard Phillips head design.

Step1: Select Driver’s or passenger side lens. Instructions will be the same.

Remove original screws (Fig.1). With the screws removed be careful

not to change the position of the taillight assemble. Note the size

difference of the two screws. The large size goes to the outside of the

lens (Fig.2).

Fig.1 Fig.2

1 2 3

2007 Jeep® JK Wrangler H/D Taillight Guards Kit 11226.02 (Black) 11103.03 (Stainless Steal)

Seite 2

Step2: Insert the Large 2” replacement screw through the front side of the new H/D taillight guard starting with the oute

Seite 3

Step4: With all screws and spacers properly position, proceed to tighten screws. DO NOT OVER TIGHTEN, it is possible to crac

Keine Kommentare

Rugged-ridge Tail Light Euro Guards, 07-14 Jeep Wrangler (JK) Bedienungsanleitung